s i s t e m a o p e r a c i o n a l
m a g n u x l i n u x
~/
·
documentação
·
suporte
·
sobre
Next
Previous Contents
Linux DPT Hardware RAID mini-HOWTO
Ram Samudrala
(me@ram.org)
v1.5, February 20, 2001
How to set up hardware RAID under Linux.
1.
Introduction
2.
Supported controllers
2.1 DPT controllers
2.2 ICP vortex controllers
3.
What hardware should be used?
3.1 Controller type
3.2 Enclosure type
4.
Installation
4.1 Installing and configuring the hardware
4.2 Configuring the kernel
4.3 Bootup messages
5.
Usage
5.1 fdisk, mke2fs, mount, etc.
5.2 Hot swapping
5.3 Performance
6.
Features in the EATA DMA driver
7.
Troubleshooting
7.1 Upon bootup, no SCSI hosts are detected
7.2 RAID configuration shows up as N different disks
7.3 Machine/controller is shut down in the middle of a format
7.4 SCSI_ABORT_BUSY errors produced during initial filesystem format
7.5 If all fails...
8.
References
9.
Acknowledgements
Next
Previous Contents
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .. .. .. .. .. .. .. .. .. .. .. .. .. .. ... ... ... ... ... ... ... ... .................................................
Todas a marcas e direitos autorais desta página são de propriedade de seus autores e/ou detentores de direitos.
Copyright © 1998-2003 Flávio Veloso. Todos os direitos reservados. All rights reserved.
Linux é marca registrada de Linus Torvalds. Magnux Linux é marca registrada de Flávio Veloso.