Next
Previous
Contents
I've just discovered that some of the documentation below is obsolete.
In particular, the init daemon that comes with
the latest sysvinit package
is more sophisticated than I've portrayed it to be. Although it seems
that the current version is backward compatible with what's written
here, it looks like it has some undocumented features which are
very important for UPS support.
The control mechanism outlined below only allows powerd to give
init one of two messages, namely powerfail or powerok.
init runs one command when it receives powerfail, and another
when it receives powerok. This leads to complicated powerd
logic for dealing with low battery signals and other sorts of special
situations.
Newer versions of init (as of version 2.58, it seems) are more
sophisticated. These versions can be signaled to run one of
three scripts. Thus, init can have a powerfail script
for announcing a power outage, a powerfailnow script for doing an
immediate shutdown, and a powerok script for halting any pending
shutdowns. This is much cleaner than the gyrations one would have to
go through with the mechanisms detailed below.
Although most of the discussion here assumes the old init
communication method, I just added two new sections where the authors
uses the new communcation method. These are sections
Trust Energy Protector 400/650 and
APC Smart-UPS 700. The former is especially detailed. Both include a
powerd.c which signals init to do an immediate shutdown when
a low battery signal is received, as well as the relevant
/etc/inittab lines to make this work. Other than this, all I
can tell you is to look at the source code for init.
Also, for all I know, many of the software packages listed below also
use this newer communication method.
Next
Previous
Contents
|
