Chapter 8. Mid Level, Unifying layer

Table of Contents
8.1. boot parameters
8.2. module parameters
8.3. proc interface

The SCSI mid level is common to all usage of the SCSI subsystem. Probably its most important roll is to define internal interfaces and services that are used by all other SCSI drivers. These internal mechanisms are not discussed in this document [see ref: W2].

The primary kernel configuration parameter "CONFIG_SCSI" determines whether the mid level is built in (when "=y") or a module (when "=m"). If "CONFIG_SCSI=m" then all other SCSI subsystem drivers must also be modules.

When the mid level is built as a module then it probably never needs to be loaded explicitly because using 'modprobe' to load any other SCSI subsystem module will cause the mid level to be loaded first (if it is not already).

Some upper and lower level drivers do not (fully) load if there are no devices for that driver to control. Sometimes the report is loud as in this case for the imm driver which controls zip drives connected to a parallel port:

$ modprobe imm                                 
   imm.o: init_module: No such device

lsmod will not show the "imm" module as loaded. In other cases the result is more subtle. For example, if the sg driver is loaded in a system with no (real or pseudo) scsi devices then the /proc/scsi/sg directory will not appear. [It will be created when the first scsi device is recognized.]