6. Tell the Driver the Configuration

6.1 Introduction

Just how this is done depends upon the driver. Some drivers have more than one way to find out how their physical device is configured. At one extreme is the case where you must hard-code the bus-resources into the kernel and recompile. At the other extreme, the driver does everything automatically and you have nothing to do. It may even set the bus-resources in the hardware using PnP methods.

In the middle are cases where you run a program to give the resource info to the driver or put the info in a file. In some cases the driver may probe for the device at addresses where it suspects the device resides. It may then try to test various IRQs to see which one works. It may or may not automatically do this. In other cases the driver may use PnP methods to find the device and how the bus-resources have been set, but will not actually set them. It may also look in some of the files in the /proc directory.

One may need to give the bus-resources as a parameter to the kernel or to a loadable module. See /usr/lib/modules_help/descr.gz for a list of possible parameters. The module to load is listed in /etc/modules along with its parameters. In some other case the bus-resources may be given as parameters to the kernel. These are put into the lilo.conf file as append="...". Then the lilo program must be run to save this in the kernel boot code.

While there is great non-uniformity about how drivers find out about bus-resources, the end goal is the same. If you're having problems with a driver you may need to look at driver documentation (check the kernel documentation tree). Some brief info on a few drivers is presented in the following sections:

6.2 Serial Port Driver: setserial

For the standard serial port driver (not for multiport cards) you use setserial to configure the driver. It is often run from a start-up file. In newer versions there is a /etc/serial.conf file that you "edit" by simply using the setserial command in the normal way and what you set using setserial is saved in the serial.conf configuration file. The serial.conf file should be consulted when the setserial command runs from a start-up file. Your distribution may or may not set this up for you.

There are two different ways to use setserial depending on the options you give it. One way is used to manually tell the driver the configuration. The other way is to probe at a given address and report if a serial port exists there. It can also probe this address and try to detect what IRQ is used for this port. The driver runs something like setserial at start-up but it doesn't probe for IRQs, it just assigns the "standard" IRQ which may be wrong. It does probe for the existence of a port. See Serial-HOWTO for more details.

For PCI serial, the serial driver may detect certain modems and configure the bus-resources.

6.3 Sound Card Drivers

OSS-Lite

You must give the IO, IRQ, and DMA as parameters to a module or compile them into the kernel. But some PCI cards will get automatically detected (likely by using the lspci command or the like). RedHat supplies a program "sndconfig" which detects ISA PnP cards and automatically sets up the modules for loading with the detected bus-resources.

OSS (Open Sound System) and ALSA

These will detect the card by PnP methods and then select the appropriate driver and load it. It will also set the bus-resources on an ISA-PnP card. You may need to manually intervene to avoid conflicts. For the ALSA driver, support for ISA-PnP is optional and you may use isapnp tools if you want to.